Transcription

ASSURELOCATETMTeen Tracker Fleet TrackingLMU 2620 Install GuideThe LMU-2600 is a robust, affordable device you can count on forAVL and fleet applications. The LMU-2600 incorporates GSM/GPRS, CDMA 1xRTT, or HSPA wireless communication along withextra-sensitive GPS, a powerful processing engine, and a 3-axisaccelerometer that detects and acts on hard braking, aggressiveacceleration, or vehicle impacts. Internal or external antennaoptions enables the device to be mounted virtually anywhere foreasy, inexpensive installations. Copyright 2016 - AssureLocate.com1

To begin installation, place the vehicle tracking device under the dashboard. To prevent the unitfrom moving or falling it is recommended to use a zip-tie to secure the CalAmp. When wiring yourCalAmp Harness there are a few things you will need to know. The three wires to make the harnesswork are the Red (Constant Power Source), White (Ignition Source), Black (Ground).5C848-8 Harness5C888 Harness Copyright 2016 - AssureLocate.com2

5C867 Harness5C908 HarnessSecurely attach the wiring harness to the CalAmp and find a constant 12 VDC power source. Connect theconstant 12 VDC power source to the red wire on the tracking device. Next find the ignition wire on thevehicle and connect it to the ignition input in the fuse box. Finally, connect the ground wire on theharness to the vehicle ground (chassis). Copyright 2016 - AssureLocate.com3

Power (Red Wire)The red wire must be connected to a constantpower source. Proper wiring will ensure youreceive accurate reporting’s within the CometTracker application. Incorrect wiring of the redwire can cause the unit to show incorrect powerup events. Good sources are (Battery, AlarmSystem, and Clock).Ignition (White Wire)A switched power source is only on when the ignition is keyed — connect your white harness cable to aswitched power source, so that the CalAmp performs the Ignition Off when you turn off the car, andIgnition On when the vehicle is powered on. Good sources are (Ignition Switch in fuse box, fuel pump). Copyright 2016 - AssureLocate.com4

An additional option would be to purchase aspecific fuse which is available at most autostores and allow you to connect the ignition wiredirectly to the fuse box.Ground (Black Wire)A good ground connection is vital for proper CalAmp performance. When wiring the black (Ground) wirefrom the harness, look for a bolt, screw, or wire that contacts the bare metal of your vehicle’s chassis.Loosen the bolt, slip the ground wire underneath, and then tighten the bolt. If your ground wire doesn’tcontact bare metal, your CalAmp won’t operate. A loose or weak ground connection can result ininconsistent readings from your CalAmp. Copyright 2016 - AssureLocate.com5

Pin12345678910Additional connections for the 5C867 and 5C908Wire TableColor Description PinColorDescriptionnc-11YellowOutput 2Green Output 012OrangeInput 2Blue Input 113nc-nc-14RedPrimary PowerPink ADC 115BlackGroundViolet Input 316Black1-Bit Bus GroundGray Input 417nc-White Ignition18nc-nc-19nc-Brown Output 120nc--Wire Table Copyright 2016 - AssureLocate.com - Toll free #: 1-800-734-98852888 East Loker Ave, Suite 216 Carlsbad, California – 92010www.AssureLocate.com

Teen Tracker Fleet Tracking The LMU-2600 is a robust, affordable device you can count on for AVL and fleet applications. The LMU-2600 incorporates GSM/G-PRS, CDMA 1xRTT, or HSPA wireless communication along with extra-sensitive GPS, a powerful processing engine, and a 3-axis accele